The entry in the interface configuration table remains.īetween devices attached to the same VLAN of the VLAN-based router interface, the switch exchanges data packets on Layer 2. If there are no active ports that are a part of the VLAN-based router interface, then the entry from the routing table is removed, because the router transmits exclusively to those ports for which the data transfer is likely to be successful. Good planning of the subnetworks with the corresponding network masks makes the router configuration much easier.Īlong with enabling the global routing function, the router basic settings also contain the assignment of IP addresses and network masks to the router interfaces, and then enabling the routing function on that specific interface.Ī VLAN-based router interface is one or more physical ports that are combined using VLANs to build a virtual router interface. The configuration of the routing function usually contains the following steps:Ĭreate a picture of your network so that you can clearly see the division into subnetworks and the related distribution of the IP addresses. With the introduction of the HiOS firmware version 07.0.00, the switch agent’s Graphical User Interface (GUI) has been changed from a Java based interface to a HTML v5 interface.
This article describes the basic steps required to configure VLAN-Based (Virtual ) Router Interfaces on Hirschmann Platform V Layer 3 switches running the HiOS firmware version 07.0.00 or higher and the new HTMLv5 Graphical User Interface (GUI).
0 kommentar(er)
